Kawasaki Z1000 Forum banner
1 - 5 of 5 Posts

·
Premium Member
Joined
·
1,727 Posts
Discussion Starter · #1 ·
I can't seem get to rout my throttle cable its like there too long. When I turn right there ok but when I turn left they get pinched between the fork leg and the radiator mount. any help thanks.:screwy::screwy::screwy:
 

·
Registered
Joined
·
30 Posts
I've got the same issue on my 2011. Haven't found a decent solution yet.
bro, mine oso like that. i think all standards comes like that..u cannot pull the cables any further..

nevermind to me, as long as no idling change when i turn the handle
 

·
Premium Member
Joined
·
1,727 Posts
Discussion Starter · #5 ·
I fixed my cables. :) First I run the cables through the brace on the frame, then I had to replace the bolt that holds the head light on with a flat head screw, Then run the cables over the head light brackets too the throttle. Then I re-drilled the pilot hole to adjust the throttle cables to the right position. The reason for changing the head light bolt was when I turn the handle bar left then back right the cables would hang up on the round bolt. If you have ever taken off your wind shield you will know what I'am talking about.
 
1 - 5 of 5 Posts
Top