Kawasaki Z1000 Forum banner
1 - 7 of 7 Posts

·
Registered
Joined
·
24 Posts
Discussion Starter · #1 · (Edited)
Yes i took the gamble of ordering a set of them directly from aaron at 905 even though i had not seen any installed anywhere on a z1000 so here are the pics

I am satisfied with the fit and quality but installation was not the easiest and not all the hardware that was sent was necessary.

It is a 2003 z1k and they ran me out the door 180 bucks
 

Attachments

·
Registered
Joined
·
2,318 Posts
they look functional.... +1
 

·
Registered
Joined
·
5,210 Posts
$180. not bad. looks like they will do the job
 

·
Registered
Joined
·
117 Posts
How did you know where to cut on the sides? Did they provide templates? If not, thats a jam-up job. Looks like it came that way. Nice job...
 

·
Registered
Joined
·
24 Posts
Discussion Starter · #5 ·
How did you know where to cut on the sides? Did they provide templates? If not, thats a jam-up job. Looks like it came that way. Nice job...

No they didnt but they should have it wasnt easy so i apprecate the :+1: i used a dremel with a round 1" diameter sander bit it took about an hour to cut both.
 

·
Super Moderator
Joined
·
3,069 Posts
You have to order direct from 905. You probably have to call them to order it. She told me she was going to get the 3rd gen listed up there but they never have.

Racing 905 ? San Diego CA.
 
1 - 7 of 7 Posts
Top