Kawasaki Z1000 Forum banner
1 - 3 of 3 Posts

· Registered
4 Posts
Discussion Starter · #1 ·
Im rebuilding my 89 ZX1000 and i have everything ready to go together, but my service manual doesnt say anything about aligning the counter balance shaft with the crank shaft. The counter weight has a dot on it but there is no marks at all on the crank shaft. I need some one to help me out with my problem i have a good idea but i dont want to get it all together just to find out i was wrong and i wasted all that money for nothing. If you know or think you might be able to tell me how to figure it out please contact me.
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.